Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - dwardio

Pages: 1
TinyDuino Processors & TinyShields / Re: TinyScreen+ and Codebender?
« on: March 15, 2016, 10:59:38 AM »
Thanks, Ben!  I received the same answer from Codebender yesterday.

While I haven't seen any explicit documentation suggesting that TS+ is compatible with Codebender, it seemed plausible given the use of Codebender on over a dozen "Using the ..." tutorials on the Tiny Circuits site.

You bring up an excellent point, btw — I haven't found any TS+ documentation of any sort on the TinyCircuits website/forum!  Here's the only functional reference to the TS+ I've found so far: (from

TinyDuino Processors & TinyShields / TinyScreen+ and Codebender?
« on: March 11, 2016, 04:07:39 PM »
Has anyone successfully used Codebender with the TinyScreen+ (O Watch)?  I've signed up, installed plugins & drivers, etc., and Codebender successfully(?) identifies my board as a Tinyduino on the correct port, but reports that my device is unresponsive.  All is well via the Arduino IDE.  Is this worth pursuing, or is the TS+ just not supported? 

Not sure this is relevant to your situation, but I have been having connection problems between my O Watch (TS+) and my mac.  I found that if I use Tools|Port in the Arduino IDE to select a different port (doesn't matter which one), then re-select the correct one (cu.usbmodem1411 in my case), everything magically works.

Does "cu.usbmodemxxxx" show up in your port list when the O Watch is plugged in (and turned on)?

Pages: 1
SMF spam blocked by CleanTalk