Messages

1

TinyDuino Processors & TinyShields / Re: TinyScreen+ and Codebender?

« on: March 15, 2016, 10:59:38 AM »

Thanks, Ben!  I received the same answer from Codebender yesterday.

While I haven't seen any explicit documentation suggesting that TS+ is compatible with Codebender, it seemed plausible given the use of Codebender on over a dozen "Using the ..." tutorials on the Tiny Circuits site.

You bring up an excellent point, btw — I haven't found any TS+ documentation of any sort on the TinyCircuits website/forum!  Here's the only functional reference to the TS+ I've found so far: http://bit.ly/TinyScreenPlus (from theowatch.com).

2

TinyDuino Processors & TinyShields / TinyScreen+ and Codebender?

« on: March 11, 2016, 04:07:39 PM »

Has anyone successfully used Codebender with the TinyScreen+ (O Watch)?  I've signed up, installed plugins & drivers, etc., and Codebender successfully(?) identifies my board as a Tinyduino on the correct port, but reports that my device is unresponsive.  All is well via the Arduino IDE.  Is this worth pursuing, or is the TS+ just not supported? 

3

TinyDuino Processors & TinyShields / Re: TinyScreen+ (0-watch) Stopped Showing As Available Port -any suggestions?

« on: March 11, 2016, 03:34:04 PM »

Not sure this is relevant to your situation, but I have been having connection problems between my O Watch (TS+) and my mac.  I found that if I use Tools|Port in the Arduino IDE to select a different port (doesn't matter which one), then re-select the correct one (cu.usbmodem1411 in my case), everything magically works.

Does "cu.usbmodemxxxx" show up in your port list when the O Watch is plugged in (and turned on)?