Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - lolsnub

Pages: 1
Hi, I am still new with tiny durino so still dont understand how to change the interrupt signal from R2 to R3.

I had used this guide and shown:

The interrupt signal can be changed from pin 2 to pin 3 by removing resistor R2 and soldering it to position R3.

I had done the soldering to R3 but how to change the default from R2 to R3 base on the guide?

Pages: 1
SMF spam blocked by CleanTalk