Show Posts
1
TinyDuino Processors & TinyShields / Need help with bluetooth interrupt signal
« on: November 18, 2022, 10:04:35 PM »
Hi, I am still new with tiny durino so still dont understand how to change the interrupt signal from R2 to R3.
I had used this guide https://learn.tinycircuits.com/Communication/Bluetooth-Low-Energy_TinyShield_Tutorial/ and shown:
NOTE:
The interrupt signal can be changed from pin 2 to pin 3 by removing resistor R2 and soldering it to position R3.
I had done the soldering to R3 but how to change the default from R2 to R3 base on the guide?
I had used this guide https://learn.tinycircuits.com/Communication/Bluetooth-Low-Energy_TinyShield_Tutorial/ and shown:
NOTE:
The interrupt signal can be changed from pin 2 to pin 3 by removing resistor R2 and soldering it to position R3.
I had done the soldering to R3 but how to change the default from R2 to R3 base on the guide?