1
General Discussion / I am the new guy
« Last post by TEDJoie35 on Today at 05:20:29 PM »I genuinely enjoy reading through on this site, it holds superb content.
Recently I've discovered this design for a 0.4" x 0.4" arduino compatible board:
https://hackaday.io/project/3117-a-even-smaller-nanite slice master
My proposal:
- a similarily sized Tinyduino, possibly powered by a small battery cell
- a neopixel addon board which can be soldered to the bottom side of the board (using spacers)
https://tinytv.us/TinyTV-Converter-App/bob the robberYou can use this method, but is there any way without downloading?
Has the apps. LMK if you can't get them and I can try to upload them somewhere.
Farewell, everyone, I'm somewhat inexperienced with this type of programming, and I'm struggling to upload a sketch onto the watch in order to proceed. Drivers, updates, and device recognition have been the least difficult things thus far, but the integrated development environment (IDE) is giving me a headache, gorilla tag so I'm not sure what to do next. Here is a screenshot showing the faults. What am I not seeing? Does any library have an error? Nothing has worked since I went to github to grab the new library files.geometry dash liteI also have the same issue. Did you find any solution?
Could you please lend me a hand? I'm very unprepared and I simply wanted to show myself that I could pull this off.
Hello,
To preface, I tried to change the 'Preferences' in Finder, but it did not make a difference.
I am not able to see the removable disc when I check Disc Utility. I have a new USB-C cord I just purchased. I have the files downloaded and converted, I cannot drag them into the Tiny Tv 2 application.
I just needed some troubleshooting advice.
I am using macOS Monterey (Version 12.7.4).
Cheers!