Recent Posts

1
General Discussion / I am the new guy
« Last post by GingerKers on Today at 04:04:31 AM »
Link exchange is nothing else however it is simply placing the other person's web site link on your page at proper place and other person will also do similar for you.
2
General Discussion / Just want to say Hello.
« Last post by Booker36F on Today at 01:34:50 AM »
Hello, after reading this amazing post i am also glad to share my knowledge here with colleagues.
3
General Discussion / Just want to say Hi!
« Last post by BobRuk758 on Today at 01:27:59 AM »
Rattling clear web site, thanks for this post.
4
General Discussion / I am the new girl
« Last post by BertieStoo on May 19, 2024, 09:07:17 PM »
It's enormous that you are getting thoughts from this paragraph as well as from our dialogue made here.
5
General Discussion / Can you identify this connector?
« Last post by zaklee on May 17, 2024, 12:46:25 PM »
I'm trying to identify a small, rectangular, 2-pin connector for 20 AWG wire on a 24 volt circuit. The connector is approx. 7.75mm long x 5.7mm wide x 4mm tall. With the key on the top it's 4.85mm tall.

I've attached a couple of photos. Hopefully someone knows what it is!

Thanks,
Zak


6
https://tinytv.us/TinyTV-Converter-App/bob the robber

Has the apps. LMK if you can't get them and I can try to upload them somewhere.
You can use this method, but is there any way without downloading?
7
Quote
Farewell, everyone, I'm somewhat inexperienced with this type of programming, and I'm struggling to upload a sketch onto the watch in order to proceed. Drivers, updates, and device recognition have been the least difficult things thus far, but the integrated development environment (IDE) is giving me a headache, gorilla tag so I'm not sure what to do next. Here is a screenshot showing the faults. What am I not seeing? Does any library have an error? Nothing has worked since I went to github to grab the new library files.geometry dash lite

Could you please lend me a hand? I'm very unprepared and I simply wanted to show myself that I could pull this off.
I also have the same issue. Did you find any solution?
8
Hello,
 :)

To preface, I tried to change the 'Preferences' in Finder, but it did not make a difference.

I am not able to see the removable disc when I check Disc Utility. I have a new USB-C cord I just purchased. I have the files downloaded and converted, I cannot drag them into the Tiny Tv 2 application.

I just needed some troubleshooting advice.

I am using macOS Monterey (Version 12.7.4).

Cheers!

Hi,

When you plug the TV into your computer does the screen on the TV say anything about being in "USB Mode?"
9
Hello,
 :)

To preface, I tried to change the 'Preferences' in Finder, but it did not make a difference.

I am not able to see the removable disc when I check Disc Utility. I have a new USB-C cord I just purchased. I have the files downloaded and converted, I cannot drag them into the Tiny Tv 2 application.

I just needed some troubleshooting advice.

I am using macOS Monterey (Version 12.7.4).

Cheers!
10
I didn't initially find this page until after I posted. I hope this covers everything I was/am looking for. If you have further suggestions though please comment.
https://learn.tinycircuits.com/Processors/TinyScreen+_Setup_Tutorial/
SMF spam blocked by CleanTalk