I have been building a Thermostat project for the refrigerator in my RV. The circuit is built and tested as functional. It is comprised of a TS+ with a custom expansion board which contains the added circuitry and switches. I am beginning to layout a cnc milled enclosure. From a previous topic, TS+ eagle files, and the data sheet for the display module, I was able to get the required thicknesses and basic measurements. but am still missing a few key measurements.
I am looking for the measured placement of the display module on the TS+ board. The TS+ board is 25.0 x 25.8, the OLED itself is 25.70 × 22.20, the OLED viewable area is 20.14 x 13.42. Primary question, what are the X,Y coordinates of the bottom left corner of the Viewable Area in relation the TS+ Circuit board 0,0 coordinates.
I would appreciate any assistance.
Bill (an old engineer still learning)
