Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - steve77

Pages: 1
1
The TinyZero with ServoShield runs the sample program to make servos oscillate if the Serial Monitor is opened, as the instructions state.  It continues if the TZ is unplugged from the USB port, but stops and will not restart if the TZ is cycled on/off/on while unplugged from the USB.  The TZ is operating on the Lipo battery.

Is there some code I can add to the sample program so the ServoShield will operate the servos when turned on while not attached to the computer and Serial Monitor?

Pages: 1
SMF spam blocked by CleanTalk