So I'd like to stack a tiny-duino, a proto board, and a LED shield. I need to get a lead to the Analog in pin. But the prototypes shields don't have a connector on top and bottom like the Comm board does.

Hi Chuck,

You can use the TinyShield Proto Terminal Blocks. It will give you the pins off the sides, but still let you use the led shield. However, it is a bit bulkier than the other shields.

Thanks Grimstone, unless I'm mistaken that that shield, as with the other proto shields only has one connector to the TinyDuino. If you look at the Comm board it has a connector no top and on bottom. Hard to tell from the photos.

I have that board and it does indeed have a connector on the top and bottom allowing a pass through for other shields like the LED shields.