Need a proto board with dual sockets

[ChuckM]

So I'd like to stack a tiny-duino, a proto board, and a LED shield. I need to get a lead to the Analog in pin. But the prototypes shields don't have a connector on top and bottom like the Comm board does.

[Grimstone]

Hi Chuck,

You can use the TinyShield Proto Terminal Blocks. It will give you the pins off the sides, but still let you use the led shield. However, it is a bit bulkier than the other shields.

[ChuckM]

Thanks Grimstone, unless I'm mistaken that that shield, as with the other proto shields only has one connector to the TinyDuino. If you look at the Comm board it has a connector no top and on bottom. Hard to tell from the photos.

[Grimstone]

I have that board and it does indeed have a connector on the top and bottom allowing a pass through for other shields like the LED shields.