short circuit on I2C during upload?

Started by mrbbp, December 11, 2013, 05:56:03 PM

Previous topic - Next topic

mrbbp

**
Jr. Member
Posts: 8
Logged
Hello.

I'm working with 7 segments display panel from sparkfun and kill 2 display with tinylily!
Not the display itself but the atmega placed on the display's back...
It seems it arrive when uploading sketch in the tinylily.
Is it possible?
the display power are not connected with the tinylily power pin...
i use I2C connection on pin A4 and A5
I'm in trouble...
is possible or am i unlucky?

Any similar pb?

regards

éric

ps: some picture of the toy

TinyCircuits

Administrator
*****
Hero Member
Posts: 108
Logged
Hi eric,

Not sure why this would be happening, if only the I2C is attached I'm not sure how this could be happening.  Can you post a schematic / wiring diagram of how you have this connected?

Thanks,

Ken Burns
TinyCircuits

calvinthedestroyer

*****
Hero Member
Posts: 106
Logged
Quotei use I2C connection on pin A4 and A5
I thought A4 and A5 were for analog signals not digital. Shouldn't you use IO1 and IO2 for I2C?
www.DSPrototyping.com
www.youtube.com/calvinthedestroyer/

mrbbp

**
Jr. Member
Posts: 8
Logged
sorry i haven't got schematics...
Only use 4 wires
2 for I2C and 2 for power and gnd on the tinylily
had other 2 wires for display module for power and grnd... from the battery holder.




strange...

i do not understand... there is no reason to have this behavour ! perhaps, i have to protect from the battery and switch? but how?

SMF spam blocked by CleanTalk