hull/body

braza · 2 · 7004

braza

  • Full Member
  • ***
    • Posts: 22
    • View Profile
Hi all,

I know that it`s not an electronic really, but I think it`s a reasonable idea to produce some hull/body for the tinyduino sandwich. I need one and the best option for me now is a 3D print, but there are few thing that can`t be easily achieved with it. Here is my list of needs, let`s see if anybody think it makes sense for anyone else:

  • Be solid and tightly fit the sandwich, probably have its own screws and buffers for the corner holes in boards, shockproof
  • Have one side transparent so that multiled or eInk or any other displa could be read
  • Probably have the same connector as boards have and have a wire or slot connector outside of the hull
  • Be waterproof in the closed state
  • Some


flintols

  • Jr. Member
  • **
    • Posts: 6
    • View Profile
It looks like that would depend on the shield. Could easily make 3D print versions (stl files) based on board design.


 

SMF spam blocked by CleanTalk