I recently purchased a TinyShield Accelerometer from Fry's here in Dallas. Upon starting to work on my project, I learned that the TinyShield that I purchased and the one on your website are not the same.  My TinyShield (ASD2511 Rev 4) is missing the INT1 & INT2 outputs.  This is posing a problem as I need to be able to connect to INT1 at a minimum.  Is this an older board?  Is there another option for me to connect?

ASD2511 is actually our newer sensor carrier board- the single board design allows us to carry more types of sensors, at the cost of how many pins are broken out per sensor. This is something I want to improve in the next revision. For now, we have some older accelerometer boards with the interrupt pins, and can swap yours if you'd like- we'll respond to your email about that.

Thanks,
Ben

Any chance you could point me to the new schematic for the ASD2511 Rev4? I could only find your AS-SCH-ASD2611 on this site in your product's spec tab.

Respectfully,

bobg

Sorry about that, we need to update that product page. Another sensor has the Rev5 schematic, which is identical to Rev4: http://www.tiny-circuits.com/Downloads/Schematics/ASD2511_Rev5.pdf

Thanks for the quick reply! This explains my missing interrupts

Best Regards,

bobg