Show Posts
1
TinyDuino Processors & TinyShields / BLE reflashing
« on: January 30, 2015, 10:35:22 PM »
So i understand that there are 6 pins (well spots for pins) on the back of the BLE v2 board.
But, what is best practice to access these pins with the CC Debugger.
Solder a header pins on it?
Seems a bit impractical to do this.
Is there a more elegant solution for reflashing?
I assume Ken and team have some kind of 'jig' that the board slides into, gets programmed and then gets removed?
Thanks!
But, what is best practice to access these pins with the CC Debugger.
Solder a header pins on it?
Seems a bit impractical to do this.
Is there a more elegant solution for reflashing?
I assume Ken and team have some kind of 'jig' that the board slides into, gets programmed and then gets removed?
Thanks!