Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - darksheep

Pages: 1
General Discussion / Re: Is TinyDuino appropriate for beginners?
« on: July 08, 2013, 09:57:24 AM »
My friend is new to arduino and I gave him a TinyDuino, TinyShield USB & ICP and a TinyShield Proto Board 1.
I then soldered some female headers on the TinyShield Proto Board 1 and he has done  a lot of examples form the net using this setup.
For the pin question I pointed him to the forum post that explains the pins and he has worked it out for himself.

May be someone can make a table or something to make it easier for new people to work it out ,I don’t have a pc where I am now so it’s a but hard.

TinyDuino :
TinyShield USB & ICP :
TinyShield Proto Board 1:

Female headers :

You can use any headers you like with 2mm spacing,I just go these and then cut them in to 4 rows of 8

User Projects / Code Examples / Re: TinyDuino Darkness Gauge
« on: July 06, 2013, 12:45:53 PM »
This is cool :)
Did you use a resistor with the  LDR or was it just directly connected to A3 and ground ?

General Discussion / Re: tiny screen/Display
« on: July 04, 2013, 03:01:58 AM »
MMM looks cool may be you guys could make a shield for it ;)

I think I might end up going with this

Its small and lowish power so might work well.

New Product Ideas / Re: Modification of the USB + ICP shield to 3.3V
« on: July 03, 2013, 09:50:28 AM »
Yip this would be cool

General Discussion / Re: tiny screen/Display
« on: July 02, 2013, 02:35:54 AM »
If your pockets are deep, then there are also these which all seem to be in the size range you are looking for (although not very thin):,fff80276,ffec322b&stock=1

This one loooks amazing have you seen any one use it with an arduino ? 

General Discussion / tiny screen/Display
« on: July 01, 2013, 06:50:54 AM »
Any one know if there is a screen out there that is the same size as the tiny shields that I could use with my project.

So 20mm by 20mm or jsut a bit bigger is fine as well.I it operated at 3v3 volts that would be amazing as well.

Pages: 1
SMF spam blocked by CleanTalk