Show Posts
1
General Discussion / Re: Smart Watch Files
« on: May 19, 2021, 08:07:01 AM »
Hi everyone,
I ran into the same issue: opening the .slt-files provided at https://cdn.shopify.com/s/files/1/1125/2198/files/watchDesign.zip?3747 (as linked on https://learn.tinycircuits.com/Kits/TinyScreen-Smart-Watch-Kit_Tutorial/) with Ultimaker Cura results in an automatic upscaling by 10,000% which makes it way too big, but going to 100% doesn't make sense either because then the watch casing is roughly 1 cubic millimeter in size.
My best guess is that the unit used to create the .slt files is inches, hence I would have to upscale by 2540% (one inch being 25.4mm) to get the correct size in millimeters. Can anyone confirm? Or can anyone simply provide the actual dimensions of the watch casing? Couldn't find those.
Thanks,
Joachim
I ran into the same issue: opening the .slt-files provided at https://cdn.shopify.com/s/files/1/1125/2198/files/watchDesign.zip?3747 (as linked on https://learn.tinycircuits.com/Kits/TinyScreen-Smart-Watch-Kit_Tutorial/) with Ultimaker Cura results in an automatic upscaling by 10,000% which makes it way too big, but going to 100% doesn't make sense either because then the watch casing is roughly 1 cubic millimeter in size.
My best guess is that the unit used to create the .slt files is inches, hence I would have to upscale by 2540% (one inch being 25.4mm) to get the correct size in millimeters. Can anyone confirm? Or can anyone simply provide the actual dimensions of the watch casing? Couldn't find those.
Thanks,
Joachim