Messages

46

General Discussion / Re: Motor Driver Issue

« on: October 20, 2020, 03:33:41 PM »

Réna,

Thanks for the info...that seemed to do it, for now.

Regards....john

47

General Discussion / Motor Driver Issue

« on: October 20, 2020, 01:20:33 PM »

In attempting to compile the //  TinyCircuits Dual Motor Driver Basic Example - and after installing the <MotorDriver.h>, I get the following error message....'NO_R_REMOVED' was not declared in this scope...

Any ideas as to what I'm doing incorrectly - like die I install the "right" lib?

Thanks,
John

48

General Discussion / Re: Duel Motor TinyShield Schematic Issue

« on: October 06, 2020, 01:04:59 PM »

Rena,

This is what I was looking for...thanks....john

49

General Discussion / Re: Duel Motor TinyShield Schematic Issue

« on: October 05, 2020, 02:21:27 PM »

Rena,

Thanks for the fix!

Question....do mating connectors with wires exist so that one can connect (plug in) a DC motor to the board (and solder the wire ends to the motor_?

John

50

General Discussion / Re: Duel Motor TinyShield Schematic Issue

« on: October 04, 2020, 11:58:58 AM »

Looks like the entire "download" section is mistaken, as well.

And, yes, it's Dual (not Duel) Motor TinyShield...jg

51

General Discussion / Duel Motor TinyShield Schematic Issue

« on: October 03, 2020, 12:37:37 PM »

I believe that the schematic for the dual motor tinyshield is incorrect...looks like the sensor board schematic, instead.  Go here and click on schematic to confirm.  Thanks....john

https://tinycircuits.com/collections/motors-1/products/dual-motor-tinyshield

52

General Discussion / Re: GPS TinyShield does not provide actual altitude

« on: October 01, 2020, 07:13:05 PM »

Ben,

Thanks for the Beta board offer.  I, too, am working on a model rocket electronic package, as well, so this could be the "next gen" of it. 

john

53

General Discussion / Re: GPS TinyShield does not provide actual altitude

« on: September 29, 2020, 11:25:18 AM »

Ben,

When do you think the "new" tinyscreen+ board will be available - even for Beta test?


John

54

General Discussion / FLASH for EEPROM

« on: May 13, 2020, 12:06:23 PM »

Is there a "simple" way to use FLASH, like on the TinyScreen+, as EEPROM for non-volatile storage for a few variables?  That is, without plowing thru gobs of code to find out how - just a simple function would be nice.

Thanks,
John

55

General Discussion / Re: TinyZero Problems

« on: May 04, 2020, 12:01:37 PM »

Willem,

Thanks for the USB related suggestion, but I've been "successfully" programming TinyScreen+ units on a Win 10 machine (circa 2019) for sometime now. 

Even though - schematically - the TinyZero is the same as the TinyScreen+ in terms of the processor, something else is going on and I don't think it's USB related.

I think the problem is on my end, but I can't be sure.

Again, any help is appreciated.

John

56

General Discussion / TinyZero Problems

« on: May 03, 2020, 02:47:00 PM »

I purchased two (2) TinyZero Processors and neither of them work correctly. I've tried them both per below.

Most times the Bootloader won't allow me to upload the code even after following the directions on the NOTES for the TinyZero.

But once in a while the code gets uploaded.

However, even when the code loads, the COM port won't be active after the loading sequence (see attached).

I did have another TinyZero (3rd one) that did work at one point, but the fragile bootloader button broke (tore off)

To confirm things....I've reloaded the Arduino IDE, changed USB ports, changed USB cables but still no luck.

Am I missing an #include <TinyZero.h> if there is such thing??

Any help will be appreciated.

Thanks,

John

57

General Discussion / Re: Wireling Connectors

« on: February 19, 2020, 02:02:57 PM »

Please do...thanks...john

58

General Discussion / Wireling Connectors

« on: February 19, 2020, 12:16:47 PM »

Is there a "PC mate" connector (female) to the 5-pin (male) Wireling connector - one that will allow a Wireling module with the 5-pin male connector to plug directly into a PCB without a cable?

Thanks,

John

59

General Discussion / Re: Wireling Adapter

« on: January 16, 2020, 11:19:51 PM »

Got it...thanks!!....jg

60

General Discussion / Wireling Adapter

« on: January 16, 2020, 02:11:52 PM »

Is there a Learn page for just the Wireling Adapter shield?

-john