Show Posts
1
TinyDuino Processors & TinyShields / Uploading to TinyDuino
« on: November 14, 2014, 06:06:29 PM »
I would like to ask for help...
After just receiving my tinydunio starter kit I was able to upload to the processor 4 times without any errors using the Arduino IDE and codebender.
Since then, I am no longer able to upload anything from the ide or codebender. When using the ide, I get the error "avrdude: stk500_getsync(): not in sync: resp=0x00", and codebender responds upload failed
This usually means that the ide is unable to communicate with the processor, but I have a hard time believing this on such a new board.
The ftdi driver installs correctly and the assigned com port appears in device manager, and can be selected in the ide or codebender.
Any help resolving this issue would be greatly appreicated!
Thanks!
After just receiving my tinydunio starter kit I was able to upload to the processor 4 times without any errors using the Arduino IDE and codebender.
Since then, I am no longer able to upload anything from the ide or codebender. When using the ide, I get the error "avrdude: stk500_getsync(): not in sync: resp=0x00", and codebender responds upload failed
This usually means that the ide is unable to communicate with the processor, but I have a hard time believing this on such a new board.
The ftdi driver installs correctly and the assigned com port appears in device manager, and can be selected in the ide or codebender.
Any help resolving this issue would be greatly appreicated!
Thanks!