Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - scott216

Pages: 1
1
TinyDuino Processors & TinyShields / USB Shield died
« on: September 26, 2014, 09:33:52 AM »
I was programming my TinyShield and it was working pretty well.  Sometimes the output to the serial monitor was garbled, not sure why.  I clicked the upload button to upload a new sketch, and that action made my iMac reboot. After that, in the Arduino IDE, there was no USB port for the TinyShield.  I think my USB shield just died :(

2
TinyDuino Processors & TinyShields / How to use low power mode
« on: April 17, 2014, 08:27:30 AM »
I have a project where I want to use the TinyDuino and accelerometer in a low power mode.  Ideally the TinyDuino would sleep for bit, maybe 15 seconds, wake up, check the accelerometer.  I plan to attach the TinyDuino to a the side of a spool that is slowly turning (it's the filament spool for my 3D printer).  If the spool stops rotating, TinyDuino will send out a wireless signal using an RF Link like this one: https://www.sparkfun.com/products/10534.

So I need to know how to setup the TinyDuino for low power mode; I also need to setup the accelerometer for low power.  How do I do this?

Pages: 1
SMF spam blocked by CleanTalk