Messages

1

TinyDuino Processors & TinyShields / Re: How to expose sensor data by defining readable characteristics in BGLib?

« on: December 21, 2014, 05:13:14 PM »

You use the GATT_C_TX_DATA  handle to transmit data.
Here's a brief example of sending random bytes over the TinyDuino BLE shield.
This goes inside the

Code: [Select]

void loop() function of the BGLib_stub_slave() demo code.
I have a rev2 TinyDuino BLE shield FWIW.

You would read this on the master side from the Read/Notify characteristic.

Code: [Select]


         for(int i=0;i < 11;i++) {
             ble_rand_arr[i]= random(255);
             Serial.print("ble_rand_arr:");
             Serial.println(ble_rand_arr[i]);
         }
         
         //copy over to another array just to keep things clean
         uint8_t ble_tx_arr[11];
         memcpy(ble_tx_arr+0,ble_rand_arr,11);
         for (int i=0; i< 11;i++) {
              Serial.print("ble_tx_arr=");
              Serial.println(ble_tx_arr[i]);
         }

          uint8_t result = ble112.ble_cmd_attributes_write(GATT_HANDLE_C_TX_DATA,0, 11,ble_tx_arr);
         //delay a bit to make sure the other side isn't flooded.
         delay(1000);