Proto2 Board with all Digital Pins to be PWM pins (3,5,6,9,10,11), so that it adds more functionality to that tiny protoboard. As of now only pin 3 is PWM.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#1
New Product Ideas / Proto2 Board with all Digital Pins to be PWM pins
September 24, 2013, 05:12:15 PM #2
New Product Ideas / TinyDuino Ribbon Cable Shield - so that shields can be stacked sideways
September 24, 2013, 04:32:30 PM
2 suggestions
1- Stacking some shields sideways so that your TinyDuino doesnt grow upwards when using more shields.
2- Ribbon Cable Shield to pull all the points out onto a Breadboard.
1- Stacking some shields sideways so that your TinyDuino doesnt grow upwards when using more shields.
2- Ribbon Cable Shield to pull all the points out onto a Breadboard.
#3
New Product Ideas / RGB LED Shield
September 06, 2013, 02:42:39 PM
An RGB LED shield would be great. We could make a tiny lamp.
Pages1
SMF spam blocked by CleanTalk