Show Posts
1
General Discussion / Making the cap touch board more sensitive for touchless commands
« on: November 08, 2022, 04:01:50 PM »
Hello! Forgive me as I know basically nothing about all of this.
I have a wireling zero with a TinyCircuits cap touch strip. I need it to be more sensitive so that I can give inputs without actually touching it.
Is this done in the software (using CapTouchSimple) or do I need to change/add a resistor somewhere on this board?
Ultimately I am trying to sense through about 1/2" of silicone. I may extend the touch points as well if they need to be spaced further apart or if they need to be enlarged with a copper pad or something like that.
Thank you!
I have a wireling zero with a TinyCircuits cap touch strip. I need it to be more sensitive so that I can give inputs without actually touching it.
Is this done in the software (using CapTouchSimple) or do I need to change/add a resistor somewhere on this board?
Ultimately I am trying to sense through about 1/2" of silicone. I may extend the touch points as well if they need to be spaced further apart or if they need to be enlarged with a copper pad or something like that.
Thank you!