Show Posts
1
TinyDuino Processors & TinyShields / Unable to upload to Tinyscreen+
« on: May 18, 2022, 01:02:01 AM »
Trying to upload blink through Arduino IDE 1.8,13 on windows 10. I've followed the upload instructions and have confirmed all the following: Port 5 selected, Arduino Pro or Pro mini board selected, ATmega 328P 3.3v, 8MHz processor.
The IDE gets hung up on "uploading". The board is preloaded with 'flappy birdz' and it never freezes as the upload from the IDE starts. The error message is totally nondescript as well, so not much help there. Am I missing some key step?
Arduino: 1.8.13 (Windows 10), Board: "Arduino Pro or Pro Mini, ATmega328P (3.3V, 8 MHz)"
Using Port : COM5
Using Programmer : arduino
Overriding Baud Rate : 57600
An error occurred while uploading the sketch
The IDE gets hung up on "uploading". The board is preloaded with 'flappy birdz' and it never freezes as the upload from the IDE starts. The error message is totally nondescript as well, so not much help there. Am I missing some key step?
Arduino: 1.8.13 (Windows 10), Board: "Arduino Pro or Pro Mini, ATmega328P (3.3V, 8 MHz)"
Using Port : COM5
Using Programmer : arduino
Overriding Baud Rate : 57600
An error occurred while uploading the sketch