You sell lipo's that are sized nicely for the tiny duino, but it would be nice to have a lipo as an actual shield (stackable of course for more capacity!)
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
New Product Ideas / protoboard microconnector plugs/wires
March 07, 2016, 07:15:34 PM
Soldering is great for final product, but would be handy to have plugable wires that fit into the protoboard holes.
Something like this:
http://www.soundtraxx.com/access/Images/MiniMicroconnectors.jpg
Or even a special proto-board with wires/connectors similar to the 433mhz shield antenna that looks like these:
http://faddy.manufacturer.globalsources.com/si/6008802643232/pdtl/Micro-mini/1049003585/Micro-Coaxial-Connector.htm
Something like this:
http://www.soundtraxx.com/access/Images/MiniMicroconnectors.jpg
Or even a special proto-board with wires/connectors similar to the 433mhz shield antenna that looks like these:
http://faddy.manufacturer.globalsources.com/si/6008802643232/pdtl/Micro-mini/1049003585/Micro-Coaxial-Connector.htm
#3
New Product Ideas / longer mounting screws
March 07, 2016, 07:08:38 PM
I sometimes find 4 boards a bit limiting, I can work around by mounting 2 screws higher and 2 screws lower (hence only 2 screws holding a few of the boards) but would prefer dedicated mounting screws for larger stacks. More mounting screw choices in general would be great.
#4
New Product Ideas / gap connector (without shield)
March 07, 2016, 07:03:23 PM
The connector (double-sided) that is on most shields, but without the actual shield board. To allow leaving a larger gap between boards (for heatsinking, or space for proto-board wiring on the double-sided connector protoboards.
...
----- <- other boards
-
- <- gap connector
-
----- <- proto board
-
----- <- processor board
...
Pretty much like the ribbon connector but without the actual ribbon in the way.
This could also be used to jam a lipo in the gap between boards and keep things nice and clean.
...
----- <- other boards
-
- <- gap connector
-
----- <- proto board
-
----- <- processor board
...
Pretty much like the ribbon connector but without the actual ribbon in the way.
This could also be used to jam a lipo in the gap between boards and keep things nice and clean.
Pages1
SMF spam blocked by CleanTalk