TinyCircuits Forum
TinyCircuits Products => TinyDuino Processors & TinyShields => Topic started by: dwardio on March 11, 2016, 04:07:39 PM
-
Has anyone successfully used Codebender with the TinyScreen+ (O Watch)? I've signed up, installed plugins & drivers, etc., and Codebender successfully(?) identifies my board as a Tinyduino on the correct port, but reports that my device is unresponsive. All is well via the Arduino IDE. Is this worth pursuing, or is the TS+ just not supported?
-
Sorry about that- codebender does not plan to support the processor we use in TS+ in the short term.
If there is any documentation implying codebender support for TS+, could you post them? Otherwise, no problem.
Thanks,
Ben
-
Thanks, Ben! I received the same answer from Codebender yesterday.
While I haven't seen any explicit documentation suggesting that TS+ is compatible with Codebender, it seemed plausible given the use of Codebender on over a dozen "Using the ..." tutorials on the Tiny Circuits site.
You bring up an excellent point, btw — I haven't found any TS+ documentation of any sort on the TinyCircuits website/forum! Here's the only functional reference to the TS+ I've found so far: http://bit.ly/TinyScreenPlus (http://bit.ly/TinyScreenPlus) (from theowatch.com).