Hello, hoping to get some help. Super new user here. Trying to upload the pre-made code for the tinyzero. I am getting the following:
Open On-Chip Debugger 0.10.0+dev-gf0767a31 (2018-06-11-13:36)
Licensed under GNU GPL v2
For bug reports, read
http://openocd.org/doc/doxygen/bugs.html
debug_level: 2
Info : auto-selecting first available session transport "swd". To override use 'transport select <transport>'.
none separate
adapter speed: 400 kHz
cortex_m reset_config sysresetreq
Error: unable to find CMSIS-DAP device
Error: No Valid JTAG Interface Configured.
Can anyone point me to the right solution? Please dumb down your response to a newbie level :)
Thanks
Welcome to TinyCircuits! To best help out, we'll need a bit more info so we know what we're working with :)
- What pre-made code are you trying to upload? What's the project?
- Is this from TinyCircuits or somewhere else? (Could you please post a pic of your code?)
- I'll assume your accelerometer is the one built into the TinyZero board, anything else connected to it?