1
TinyDuino Processors & TinyShields / Re: BLE pin conversion kit
« on: July 13, 2014, 03:09:48 AM »
Thank you for the reply, but I don't completely understand. The website says "it can instead be connected to pin 0 if the R6 jumper is cut and a 0 ohm resistor is added to R4" and it can instead be connected to pin 1 if the R7 jumper is cut and a 0 ohm resistor is added to R5. Are you saying this can be accomplished by code and the hardware modifications are not necessary? I would really appreciate it if someone would add a link to a tutorial with pictures that illustrates the procedure if it is necessary.
Thank you very much for any information... eric
Thank you very much for any information... eric