1
TinyDuino Processors & TinyShields / Question about WiFi TinyShield. Why did it faile to get socket?
« on: February 27, 2016, 12:46:54 PM »
Hi, I have a question about WiFi TinyShield.
Now I use WiFi TinyShield and tried to run “ntpTest” which is prepared as a sample sketch of Adafruit CC3000 Library.
the sample sketch (ntp Test) was used by the tutorial of WiFi TinyShield as well.
https://www.youtube.com/watch?v=irk95KCqngQ
I run the sample sketch in the same way as the tutorial, but I got the following message from serial monitor.
I could connect to the wifi, however failed to get socket.
Why couldn’t the shield get socket ? Tell me please.
PC: Mac
Arduino: ver 1.6.7
—————————Message from serial monitor—————————
Now I use WiFi TinyShield and tried to run “ntpTest” which is prepared as a sample sketch of Adafruit CC3000 Library.
the sample sketch (ntp Test) was used by the tutorial of WiFi TinyShield as well.
https://www.youtube.com/watch?v=irk95KCqngQ
I run the sample sketch in the same way as the tutorial, but I got the following message from serial monitor.
I could connect to the wifi, however failed to get socket.
Why couldn’t the shield get socket ? Tell me please.
PC: Mac
Arduino: ver 1.6.7
—————————Message from serial monitor—————————
Code: [Select]
Hello, CC3000!
Free RAM: 821
Initialising the CC3000 ...
Firmware V. : 1.32
Deleting old connection profiles
Attempting to connect to “myNetwork”
Connected!
Request DHCP
UpdateNTPTime
sntp.update
Failed to get a socket
exit sntp.update
m_std_UTC_offset.seconds: FFFFB9B0
m_dst_UTC_offset.seconds: FFFFC7C0
Closing the connection