1
New Product Ideas / More I/O for TinyLily
« on: November 03, 2012, 12:06:58 PM »
I think TinyLily is a fantastic board. However, for many applications there are really too few I/O pins. I understand, that there is no space for more sewtabs.
But it should be possible to add small solder pads for the remaining I/O lines on the back (just like the ISP pads).
Personally I do not like the current connector for serial programming. It takes a lot of space and requires solder pads on both sides of the board. I think that five flat large pads on the front side would be a better solution. You could use a small peg-style connector for programming the device.
With this small modification the TinyLily can be used for almost all Arduino applications!
But it should be possible to add small solder pads for the remaining I/O lines on the back (just like the ISP pads).
Personally I do not like the current connector for serial programming. It takes a lot of space and requires solder pads on both sides of the board. I think that five flat large pads on the front side would be a better solution. You could use a small peg-style connector for programming the device.
With this small modification the TinyLily can be used for almost all Arduino applications!