Messages

1

TinyDuino Processors & TinyShields / Re: WIFI Shield

« on: September 01, 2016, 09:14:01 PM »

Yes and no.  Game plan is to setup several long range wifi extenders.  This should be fine for the purposes I need.  So I could take it outside and it broadcast the GPS position of the devise via the Internet.  I could set it up on a cellular network, but for now I want to set it up on wifi.

Does anyone know a tutorial series or class on working with this kind of thing that's useful?

2

TinyDuino Processors & TinyShields / Re: WIFI Shield

« on: August 24, 2016, 10:35:08 PM »

   Sorry, took me a little while to respond.  (Side question, is there a way to set up email notifications of when these are answered?).  Below is what I get when I run the NTPTime Example Sketch.  I'm not sure what it means by "Failed to get a socket".  The code doesn't have this phrase in it, so I'm assuming it is being broadcast from the site. 
   I also noticed some initializing text that didn't show up in the feedback from the device.  I am using the Tiny WIFI shield, the Battery Processor Shield, and the standard USB board.


DI�Firmware V. : 1.32

Deleting old connection profiles

Attempting to connect to ABERLY
Connected!
Request DHCP
UpdateNTPTime
sntp.update
Failed to get a socket
exit sntp.update
m_std_UTC_offset.seconds: FFFFB9B0
m_dst_UTC_offset.seconds: FFFFC7C0


Closing the connection

My goal:  I just want to create a gps tracker that transmits the location via wifi to my computer or a website.  I also have a question about converting the bod rate between the two devices.  The GPS operates at 9200 and the wifi at 115200.  If any one wants to take a stab at helping this beginner.
Side Note:  I did try the codebender.cc script, but it was having an issue locating the library.

3

TinyDuino Processors & TinyShields / Re: WIFI Shield

« on: August 12, 2016, 04:21:45 PM »

??

4

TinyDuino Processors & TinyShields / WIFI Shield

« on: August 03, 2016, 10:27:25 PM »

I'm trying to use the wifi shield, but it seems to be getting stuck at the initialize state in the buildtest (adafruit library).  Can someone help me out?  I've declared all the appropriate pins, changed the SSID and Password, but it starts the code, then stops at the initialize face.