TinyCircuits Forum
General Category => General Discussion => Topic started by: jgavlik on October 03, 2020, 12:37:37 PM
-
I believe that the schematic for the dual motor tinyshield is incorrect...looks like the sensor board schematic, instead. Go here and click on schematic to confirm. Thanks....john
https://tinycircuits.com/collections/motors-1/products/dual-motor-tinyshield
-
Looks like the entire "download" section is mistaken, as well.
And, yes, it's Dual (not Duel) Motor TinyShield...jg
-
John,
It looks like some recent updates went wrong on this page. I will fix them up today.
Thanks for the catch and letting us know!
-
Rena,
Thanks for the fix!
Question....do mating connectors with wires exist so that one can connect (plug in) a DC motor to the board (and solder the wire ends to the motor_?
John
-
John,
We do have 2-pin JST cables that you could solder onto a motor to use with the Dual Motor TinyShield: https://tinycircuits.com/collections/cables-connectors/products/jst-sh-2-pin-connector
We also have 3-pin JST cables for servos if you were interested in those as well: https://tinycircuits.com/collections/cables-connectors/products/3-pin-jst-sh-pigtail-100mm
Hope that helps!
-
Rena,
This is what I was looking for...thanks....john