TinyCircuits Forum
TinyCircuits Products => TinyDuino Processors & TinyShields => Topic started by: flyntm on November 04, 2020, 06:30:42 PM
-
I'm trying to figure out how to hook up some Tri-Colored LEDs to a TinyDuino with a PROTO TERMINAL BLOCKS TINYSHIELD. The LEDs I'm looking at have 4 wires and the following specs.
DC 2V-2.2V(R) 3V-3.2V (G/B) Volt 20mA, Polarity (2 V) : Cathode "-" (Longer Leg) | Anode "+" (Shorter Leg)
So If I read this right, The red requires a different V than the G/B. I'd like to wire up 4 of these LEDs
I'm certainly no EE so any help you can give on how to hook this up would be appreciated. And I probably need some hints as to how to write the code too.
Or if you have a better way to approach this, I'm not stuck on these LEDs :)
Thanks so much for your kind attention.
-
Hello,
I cannot be quite sure since I don't know what exact LEDs you have, but it sounds like you have tricolor LEDs that may require some resistors to be connected in series with each of the "colored" leads. I found a tutorial that might be helpful: https://create.arduino.cc/projecthub/muhammad-aqib/arduino-rgb-led-tutorial-fc003e
I believe the best way to approach would be to use some RGB LED Wirelings (https://tinycircuits.com/collections/wirelings/products/serial-rgb-led-wireling) and a Wireling Adapter TinyShield (https://tinycircuits.com/collections/wirelings/products/wireling-adapter-tinyshield) - this way you do not have to worry about connecting these tricolor LEDs and keeping track of the pins, just the labeled ports - you can also string them together, and there is an easy-to-use library, FastLED, that includes a lot of functionality that makes it easy to work with.
It depends on what you would like to accomplish!
I hope that helps!
Thanks
-
That was very helpful. Thank you. The wirelings seem like a great idea but my project is for the outdoors. I don't see a good way to weatherize the RGB LED Wireling.
-
The link you sent me was quite helpful and I'm hoping you can point me in the right direction a bit further. The link you provided showed me how to power the LEDs from the Arduino, but what I really need to do is power the LEDs from a separate 12 V power source but control them from the Arduino. Can you point me at something to give me a hit as to how to go about this?
-
I would say that you might need a voltage regulator to step down the voltage.
You can look for more resources on the Arduino forum: https://forum.arduino.cc/
Or I would advise you to contact the vendor of your tricolor LEDs and ask them.