1
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: 1
2
TinyDuino Processors & TinyShields / Re: GPS Data and Failure of Tinyduino to Turn Back On
« on: January 26, 2016, 02:33:48 PM »The power issue sounds like the GPS module isn't being switched on correctly. Let us know if the newer code fixes that.I have the same issue with the system starting up as well. A short term work around, has been to have the system plugged into the USB, and then turn on the port monitor, and watch the gps data. I then unplug the USB module while the system is running live. The system will continue to run and collect GPS data.
However, if I cycle power, it will not start up again, until I go through the port monitor sequence again.
3
TinyDuino Processors & TinyShields / Re: GPS Data and Failure of Tinyduino to Turn Back On
« on: January 26, 2016, 02:28:38 PM »$GPGGA,,,,,,0,00,,,M,0.0,M,,0000*48
$GNGNS,,,,,,NN,00,,,0.0,,0000*7D
$GNGSA,A,1,,,,,,,,,,,,,,,*0
NC,,,,,4
$GPGGA,,,,,,0,00,,,M,0.0,M,,0000*48
$GNGNS,,,,,,NN,00,,,0.0,,0000*7D
$GNGSA,A,1,,,,,,,,,,,,,,,*0
NM,,,,,4
$GPGGA,,,,,,0,00,,,M,0.0,M,,0000*48
$GNGNS,,,,,,NN,00,,,0.0,,0000*7D
$GNGSA,A,1,,,,,,,,,,,,,,,*0
GM,,,,,*
$GPGGA,,,,,,0,00,,,M,0.0,M,,0000*48
$GNGNS,,,,,,NN,00,,,0.0,,0000*7D
$GNGSA,A,1,,,,,,,,,,,,,,,*0
NM,,,,,4
$GPGGA,,,,,,0,00,,,M,0.0,M,,0000*48
$GNGNS,,,,,,NN,00,,,0.0,,0000*7D
$GNGSA,A,1,,,,,,,,,,,,,,,*0
GS812100,200,300,00007
GS822500,,00,,00*3$GV,,,,,,.4
GM,,,,,*
$GPGGA,,,,,,0,00,,,M,0.0,M,,0000*48
$GNGNS,,,,,,NN,00,,,0.0,,0000*7D
$GPGGA,,,,,,0,00,,,M,0.0,M,,0000*48
$GNGNS,,,,,,NN,00,,,0.0,,0000*7D
$GNGSA,A,1,,,,,,,,,,,,,,,*0
G$GPGGA,,,,,,0,00,,,M,0.0,M,,0000*48
$GNGNS,,,,,,NN,00,,,0.0,,0000*7D
$GNGSA,A,1,,,,,,,,,,,,,,,*0
N$GPGGA,,,,,,0,00,,,M,0.0,M,,0000*48
$GNGNS,,,,,,NN,00,,,0.0,,0000*7D
$GNGSA,A,1,,,,,,,,,,,,,,,*0
N$GPGGA,,,,,,0,00,,,M,0.0,M,,0000*48
$GNGNS,,,,,,NN,00,,,0.0,,0000*7D
$GNGSA,A,1,,,,,,,,,,,,,,,*0
G,00,,00,700,800,B$GV,,,,00,,00,100,200,3
LV,,,,,,.*
GR,,,,,*D$GPGGA,,,,,,0,00,,,M,0.0,M,,0000*48
$GNGNS,,,,,,NN,00,,,0.0,,0000*7D
$GNGSA,A,1,,,,,,,,,,,,,,,*0
GM,,,,,*
$GPGGA,,,,,,0,00,,,M,0.0,M,,0000*48
I just started the same project. What I found for most of the data, is that I just needed to go outside for a while, so that the GPS could acquire the satellites. After that the data started to flow in. It took a minute or so before real data showed up.
Pages: 1
SMF spam blocked by CleanTalk