TinyCircuits Forum
TinyCircuits Products => TinyDuino Processors & TinyShields => Topic started by: matt_b on December 29, 2015, 06:54:04 PM
-
Hello, newbie to arduino and tiny circuits. Ordered the processor board with coin, is it possible to connect lipo battery to the 2 pins labelled + - (next to on/off) switch.
Read in a post from 2014 that there is post saying gnd & + near main connector, but my tired old eyes cant see it.
Any help appreciated
matt_b
-
That post was talking about an older revision of the processor board. The +/- you've found are correct and meant for any battery about 3-4v, ie most lithium cells. Keep in mind your coin cell board does not have the charger on it, and there's no under-voltage protection- our cells have that built in, so make sure you have something in place.
Thanks,
Ben
-
Thankyou for the reply,
think its probably best if i order lipo powered board.
cheers
matt b
That post was talking about an older revision of the processor board. The +/- you've found are correct and meant for any battery about 3-4v, ie most lithium cells. Keep in mind your coin cell board does not have the charger on it, and there's no under-voltage protection- our cells have that built in, so make sure you have something in place.
Thanks,
Ben