TinyCircuits Forum
General Category => General Discussion => Topic started by: Tacca on July 11, 2021, 08:41:44 PM
-
Hello,
I am using the UARTPassThrough example as basis to send 9DOF wirelings data with BLE.
However, since I have 2 sensors, I am starting to wonder if there is a better way to do this.
I am calling this twice per sample (each sample is a reading from 2 wirelings sensors), with some delay between them:
if (!lib_aci_send_data(PIPE_UART_OVER_BTLE_UART_TX_TX, (uint8_t*)sendBuffer, sendLength))
{
SerialMonitorInterface.println(F("TX dropped!"));
}
I am trying to wrap my head around the specifics of this command, so I am looking something to go guide me deep in the GATT configurations, characteristics, attributes, etc.
Is there any project or code example with that in mind?
I am using a stack of:
- TinyZero
- STBLE
- WirelingAdapter[9DOFWireling;9DOFWireling]
Thank you all in advance.
-
This seems related to your other post. Do my replies there help? http://forum.tinycircuits.com/index.php?topic=2192.msg4957#msg4957 (http://forum.tinycircuits.com/index.php?topic=2192.msg4957#msg4957)