1
TinyDuino Processors & TinyShields / Re: Bluetooth Module -- receiving garbage on serial port
« on: June 20, 2014, 03:45:20 AM »
Hello,
I solved the problem, the GPIO pin 7 was pulled high by a 1K resistor(R4), which defaults the baud rate to 9600 regardless of the baud you provide.
If you want to use the software selected baud rate, disolder the Resistance R4, and it will work with whatever baud you give.
Regards,
Pratip Ghosh.
I solved the problem, the GPIO pin 7 was pulled high by a 1K resistor(R4), which defaults the baud rate to 9600 regardless of the baud you provide.
If you want to use the software selected baud rate, disolder the Resistance R4, and it will work with whatever baud you give.
Regards,
Pratip Ghosh.