Sorry, took me a little while to respond. (Side question, is there a way to set up email notifications of when these are answered?). Below is what I get when I run the NTPTime Example Sketch. I'm not sure what it means by "Failed to get a socket". The code doesn't have this phrase in it, so I'm assuming it is being broadcast from the site.
I also noticed some initializing text that didn't show up in the feedback from the device. I am using the Tiny WIFI shield, the Battery Processor Shield, and the standard USB board.
DI�Firmware V. : 1.32
Deleting old connection profiles
Attempting to connect to ABERLY
Connected!
Request DHCP
UpdateNTPTime
sntp.update
Failed to get a socket
exit sntp.update
m_std_UTC_offset.seconds: FFFFB9B0
m_dst_UTC_offset.seconds: FFFFC7C0
Closing the connection
My goal: I just want to create a gps tracker that transmits the location via wifi to my computer or a website. I also have a question about converting the bod rate between the two devices. The GPS operates at 9200 and the wifi at 115200. If any one wants to take a stab at helping this beginner.
Side Note: I did try the codebender.cc script, but it was having an issue locating the library.