1
TinyDuino Processors & TinyShields / TinyDuino + Motor TinyShield
« on: May 23, 2014, 02:25:20 PM »
From my other post you may have seen that I'm trying to figure out how to create a "custom servo" using a motorized fader.
I'm now considering the possibility of doing this with the existing tinyduino units. If I connect a Tiny Motor Shield (4x) to a TinyDuino, I would theoretically be able to control 4 virtual servos.
There are then 3 questions:
1. With a motor shield attached, are there any remaining analog input pins that I can use for monitoring the slide pot?
2. Is there any way to network multiple TinyDuinos together?
3. Would the "lilly" version of TinyDuino / Tiny Motor be a better fit for this approach?
I'm now considering the possibility of doing this with the existing tinyduino units. If I connect a Tiny Motor Shield (4x) to a TinyDuino, I would theoretically be able to control 4 virtual servos.
There are then 3 questions:
1. With a motor shield attached, are there any remaining analog input pins that I can use for monitoring the slide pot?
2. Is there any way to network multiple TinyDuinos together?
3. Would the "lilly" version of TinyDuino / Tiny Motor be a better fit for this approach?