TinyCircuits Forum
TinyCircuits Products => TinyDuino Processors & TinyShields => Topic started by: jbennett on October 20, 2015, 12:34:33 PM
-
I recently purchased a TinyShield Accelerometer from Fry's here in Dallas. Upon starting to work on my project, I learned that the TinyShield that I purchased and the one on your website are not the same. My TinyShield (ASD2511 Rev 4) is missing the INT1 & INT2 outputs. This is posing a problem as I need to be able to connect to INT1 at a minimum. Is this an older board? Is there another option for me to connect?
-
ASD2511 is actually our newer sensor carrier board- the single board design allows us to carry more types of sensors, at the cost of how many pins are broken out per sensor. This is something I want to improve in the next revision. For now, we have some older accelerometer boards with the interrupt pins, and can swap yours if you'd like- we'll respond to your email about that.
Thanks,
Ben
-
Any chance you could point me to the new schematic for the ASD2511 Rev4? I could only find your AS-SCH-ASD2611 on this site in your product's spec tab.
Respectfully,
bobg
-
Sorry about that, we need to update that product page. Another sensor has the Rev5 schematic, which is identical to Rev4: http://www.tiny-circuits.com/Downloads/Schematics/ASD2511_Rev5.pdf
-
Thanks for the quick reply! This explains my missing interrupts :)
Best Regards,
bobg