TinyCircuits Forum
General Category => General Discussion => Topic started by: JohnB on November 21, 2020, 01:07:06 PM
-
Hi, I'm new here ;) Could anybody advise. I would really appreciate it.
I have a Tinyscreen+ which seems to be stuck in Bootloader Mode. I have a few Tinyscreens+ and have recently been trying to establish IR communication between them so I may have damaged it but I'm not sure. I have tried to load an empty sketch to unlock it and sometimes it does seem to unstick itself but then it flicks back into Bootloader Mode as soon as I try to load anything that tries to bring it back to life. It there anyway of resetting it?
Please excuse my ignorance. I am an engineer but have not programmed for a while now :)
Thanks.
PS when trying to upload I get "Locked" appearing in the error report.
PROBLEM CLEARED 😄. I think it was a coms port issue. I am using a usb hub. Once I restarted everything and plugged direct to motherboard it cleared.
-
Glad to hear you could sort it out!
It seems restarting everything usually seems to do the trick for most electronics ;)