TinyCircuits Forum
TinyCircuits Products => TinyDuino Processors & TinyShields => Topic started by: Grimstone on October 19, 2016, 06:51:01 PM
-
I am using a tinyscreen+ with the IMU 9dof and SD card reader stacked together. Tried both the SD card info and the datalogger example (after setting the pin to 10). I am not getting any output at all. The serial baud rate is set to 9600. I send over a string to start, but getting no output back. Is there something additional needed to make the example work with the Tinyscreen+ over the traditional Tinyduino?
-
:-\
-
Never mind. Found it. Once again have to redefine Serial / SerialUSB.