TinyCircuits

Need a proto board with dual sockets

Need a proto board with dual sockets
« on: May 23, 2014, 12:07:47 AM »
So I'd like to stack a tiny-duino, a proto board, and a LED shield. I need to get a lead to the Analog in pin. But the prototypes shields don't have a connector on top and bottom like the Comm board does.

Grimstone

  • ****
  • 64
  • Still downloading...
    • View Profile
Re: Need a proto board with dual sockets
« Reply #1 on: May 23, 2014, 11:12:38 PM »
Hi Chuck,

You can use the TinyShield Proto Terminal Blocks. It will give you the pins off the sides, but still let you use the led shield. However, it is a bit bulkier than the other shields.

Re: Need a proto board with dual sockets
« Reply #2 on: May 24, 2014, 04:09:25 PM »
Thanks Grimstone, unless I'm mistaken that that shield, as with the other proto shields only has one connector to the TinyDuino. If you look at the Comm board it has a connector no top and on bottom. Hard to tell from the photos.

Grimstone

  • ****
  • 64
  • Still downloading...
    • View Profile
Re: Need a proto board with dual sockets
« Reply #3 on: May 25, 2014, 08:39:52 AM »
I have that board and it does indeed have a connector on the top and bottom allowing a pass through for other shields like the LED shields.