TinyCircuits

TinyScreen+ on/off switch broken... suggestions/?

TinyScreen+ on/off switch broken... suggestions/?
« on: January 18, 2020, 10:42:04 AM »
So when I was popping my TinyScreen+ into a printed case, the plastic stub of the on off switch snapped away leave a lovely smooth surface. But thats far from ideal, so I'm looking for suggestions on what to do to get it going again. Its in a very fiddly place for a replacement or removal. Any thoughts?


Re: TinyScreen+ on/off switch broken... suggestions/?
« Reply #1 on: January 22, 2020, 01:06:53 PM »
This is a lame idea, but I would suggest gluing the plastic part of the switch back on. Or if there is something else you can adhere to the broken end of the switch to make it more usable.