TinyCircuits

Trouble Uploading Sketch to TinyDuino - Smartwatch project

Trouble Uploading Sketch to TinyDuino - Smartwatch project
« on: June 05, 2018, 11:58:42 AM »
I can verify my sketch in Arduino 1.8.5. I can select the board since I see it as a usb board. When I try to upload the code, it fails. It looks like it's setting binary mode etc, but, then just fails to upload. This is following the Smart watch tutorial.

Re: Trouble Uploading Sketch to TinyDuino - Smartwatch project
« Reply #1 on: June 06, 2018, 10:35:30 AM »
Hm sounds like the TinyScreen board. Did you try the bootloader mode?
Quote
If you were able to upload a sketch to the TinyScreen+ and now it does not respond, you may need to force this into bootloader mode. To do this, power off the TinyScreen+ using the slide switch. Plug the USB cable into the TinyScreen+ and your computer. Then press and hold the button closest to the USB connector while sliding the switch to the ON position. Then try uploading your program to the TinyScreen+ and it should work. You may need to try this several times if it does not work the first time.

Re: Trouble Uploading Sketch to TinyDuino - Smartwatch project
« Reply #2 on: June 06, 2018, 02:20:20 PM »
Got it worked out. The watch kit is a TinyScreen. I also have TinyScreen+ boards. I got it sorted out. Works Great, Looks really good. Thanks for all the hard work.