TinyCircuits

TinyScreen+ Nordic BLE Paring Error

TinyScreen+ Nordic BLE Paring Error
« on: January 14, 2018, 10:52:26 AM »
Hi,
     I have a TinyScreen+ and a Nordic Bluetooth Low Energy TinyShield in my stack. I successfully compiled and am trying to run Ben Rose's "TinyCircuits NRF8001 UART Example Sketch updated" 27 May 2016 on the TinyScreen+

The only device I did not recognize in the Bluetooth setup on my android phone is named "URT". When I try to pair to the device named "URT" on my cellphone it says "Unable to communicate with URT".

I had a strange problem with the Ardunio IDE standard Serial Terminal flip-floping between COM 9 and COM 10 identified for the TinyScreen+ when the code was uploadig.

When I am successful uploading the code, the "standard" Serial Monitor from IDE outputs:

Evt Connected
Evt Pipe Status
Evt Disconnected/Advertising timed out
Advertising started

when set at either 115200 and 9600 baud rates.

Any idea what is going on?

Re: TinyScreen+ Nordic BLE Paring Error
« Reply #1 on: May 31, 2018, 04:40:02 AM »
In the news forum, knowledge will be published.