Show Posts
1
General Discussion / Can battery recharging be triggered through the Proto Board connections?
« on: August 28, 2019, 10:49:23 AM »
If I have a TinyScreen or TinyZero board with a Proto Board attached, can I apply a +5V and GND to the appropriate pins on the Proto Board to trigger the TinyScreen or TinyZero to recharge an attached battery without being connected to USB? It seems like it should work based on my reading of the schematics, but I thought I would ask before I risk frying a board.
If that's not possible, is there some other way to recharge an attached battery without being connected to USB? I ask because I have tiny robots that use these boards, and I ordered some very small 5V/300mA-max inductive charging modules from DFRobot that will be arriving shortly that I want to experiment with using on my robots, and it'd be nice if I didn't need to integrate a separate charging circuit into my existing custom PCB that they use.
These are the modules I'll be experimenting with, if that helps answer the question...
https://www.dfrobot.com/product-1283.html
Thanks in advance for any assistance on this subject anyone might provide.
Kyle
If that's not possible, is there some other way to recharge an attached battery without being connected to USB? I ask because I have tiny robots that use these boards, and I ordered some very small 5V/300mA-max inductive charging modules from DFRobot that will be arriving shortly that I want to experiment with using on my robots, and it'd be nice if I didn't need to integrate a separate charging circuit into my existing custom PCB that they use.
These are the modules I'll be experimenting with, if that helps answer the question...
https://www.dfrobot.com/product-1283.html
Thanks in advance for any assistance on this subject anyone might provide.
Kyle