Show Posts
1
TinyDuino Processors & TinyShields / Re: BLE Board sample code
« on: April 30, 2014, 11:49:41 PM »
Hello,
I cant get this to work also. I was very disappointed to find out after long hours of debugging that the R6 and R7 resisters where not populated. After adding them I still cant get this to work. I have verified that I get data to the BLE112 and it responds with something. Im using a baud rate of 38400 like the example for both the PC and the BLE. I'm using the following for BLE comm pins bleSerialPort(3, 4). What software do your modules have loaded? Does it support the ble_cmd_system_hello() function? I cant seem even get this to work. I figured when I bought this I would get up and running quickly, but this has been very very disappointing, could you help?
Luis
I cant get this to work also. I was very disappointed to find out after long hours of debugging that the R6 and R7 resisters where not populated. After adding them I still cant get this to work. I have verified that I get data to the BLE112 and it responds with something. Im using a baud rate of 38400 like the example for both the PC and the BLE. I'm using the following for BLE comm pins bleSerialPort(3, 4). What software do your modules have loaded? Does it support the ble_cmd_system_hello() function? I cant seem even get this to work. I figured when I bought this I would get up and running quickly, but this has been very very disappointing, could you help?
Luis