Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - dana8080

Pages: 1
TinyDuino / Windows 7 not identifying tinyduno when plugged in
« on: September 28, 2018, 05:00:40 PM »
I have been following your guide on how to upload video to the Tiny duino, when I get to the part where I need to go into device manager and check the "unknown device" area, I cant because there isnt an unknown device plugged in as far as windows in concerned.
I have tried:
Updating all drivers from Windows
Updating all drivers from my computer manufacturer (lenovo)
different USB ports
plugging-re plugging the tinyduino shield 110x

I am now trying to reboot the sheild but your documentation says "hold down button closest to the usb port and turn the switch back on", but there are 2 buttons the same distance from the usb and it doent seem to matter what combination i press, nothing happens, I just get the standard video the thing came with.

When its plugged in and the slide is off, it blinks orange, when its on its solid green.

Please help, is there a reset pin or gnd pin on this thing?

It is connected:  screen -> Usb -> tinyduino

Thank you

Pages: 1
SMF spam blocked by CleanTalk