TinyCircuits

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - fvoiron

Pages: [1]
1
TinyDuino / Re: TinyScreen+ and GPS module
« on: April 04, 2018, 04:13:46 PM »
Dear Ben,

Sorry to reopen an old topic but still am struggling with this old problem (and SoftwareSerialZero library).
Indeed the transmit from GPS to Tinyscreen is indeed OK (i.e. the A1 pin works well) but the transmit to the GPS seems not to work (i.e. A0 pin). i.e. I'm sending $PSRF103 commands to the GPS that doesn't work with Tinyscreen+ although the same command is working when I'am using another setup with tinyprocessor board (328P).

Have you tested the Rx/Tx both ways ?
I noticed that in SAM21D datasheet that A0 and A1 pins are different (Analog for A0 and PWM for A1) - could that be pqrt of the explanation ?

I'm quite blocked now - any help you can provide ?
Thks

2
General Discussion / GPS shield
« on: April 03, 2018, 06:23:45 AM »
Hello all,

I'm using the GPS shield for fast tracking and would like to push the update rate to 5Hz (default is 1Hz).
It is stated in the product datasheet that this can be done using NMEA command... does anybody tried it ?
What the appropriate NMEA command ? The *PSRF100 doesn't allow faster that 1s update rate whereasI would need 200ms. does anybody knows wich command to use ? is it NMEA or SPrF protocol related?

Thnaks for any support

Pages: [1]