Show Posts
1
TinyDuino Processors & TinyShields / Re: GPS TinyShield not getting location
« on: February 19, 2018, 04:48:49 PM »
O.k., the answer to this question is:
static const int RXPin = A1, TXPin = A0;
TinyGPS is located on those pins. Be sure to leave the hardware as 1,0 as those service the USB to Serial port output.
static const int RXPin = A1, TXPin = A0;
TinyGPS is located on those pins. Be sure to leave the hardware as 1,0 as those service the USB to Serial port output.
Code: [Select]
#include <TinyGPS++.h>
#include <SoftwareSerial.h>
/*
This sample code demonstrates the normal use of a TinyGPS++ (TinyGPSPlus) object.
It requires the use of SoftwareSerial, and assumes that you have a
4800-baud serial GPS device hooked up on pins 4(rx) and 3(tx).
*/
static const int RXPin = A1, TXPin = A0;
static const uint32_t GPSBaud = 9600;
Just bought the TinyGPS and exactly the same thing. All results are *** and RX keeps incrementing, but no sentences are ever processes. 1 hr outside with clear line of sight to the sky and not response.
Was there just a batch of bad GPS modules from TinyCircuits or is the same code bad for the ASD2501 (Rev 4)